CarvingBench

A working handbook for whittling and hand wood carving

Fix a problemChartsWood chartSharpening anglesGear guidesAll notes
MenuClose

The process

  1. Choose the wood
  2. Knives and tools
  3. 1Sharpen and strop
  4. 2Basic cuts and safety
  5. 3Whittling projects
  6. 4Spoon carving
  7. 5Chip carving
  8. 6Finish and repair

Reference

  • Fix a problem
  • Charts
  • Wood chart
  • Sharpening angles
  • Gear guides
  • All notes
  • Choose the wood
  • Knives and tools
  • 1Sharpen and strop
  • 2Basic cuts and safety
  • 3Whittling projects
  • 4Spoon carving
  • 5Chip carving
  • 6Finish and repair
  1. Choose the wood
  2. Knives and tools
  3. 1Sharpen and strop
  4. 2Basic cuts and safety
  5. 3Whittling projects
  6. 4Spoon carving
  7. 5Chip carving
  8. 6Finish and repair
Handbook / Fix a problem

Fix a problem

What went wrong, and what to change

Start from what you see. Each note gives the likely causes in order and one change to make on the next try.

  • Knife will not cut and the hand hurtsWhittling feels hard when the edge is dull, the wood is over about 600 lbf or the cut runs against the grain. Six causes, the sign of each and the fix.Basic cuts and safety→
  • Dry wood is too hard to carveSoaking a whole block is not standard: it can split as it dries. A light mist of half rubbing alcohol, half water is the usual fix. Methods compared.Choose the wood→
  • A wood carving has cracked or a part broke offMatch the crack to the fix: glue and clamp, glue with sawdust, a wood sliver or epoxy. Clamp 30 to 60 minutes, wait 24 hours, then slow the drying.Finish and repair→

Carving Bench

A working handbook for whittling and hand wood carving. Gear picks are chosen from what the Amazon listings state, not from hands-on tests. How that works.

AboutHow we pick gearContactAffiliate disclosurePrivacy

© 2026 Carving Bench. As an Amazon Associate I earn from qualifying purchases. Prices and availability are shown as of the time stated and can change.